Sunday 12 June 2016

OLD DOWNS PURSUITS HFT and Clay








Got a voucher for four free sessions at Old Down Pursuits rifle club off the Wifey Christmas just gone, so due to the fact that sessions are every second sunday and crap weather in general, i finally got to go. Its the other side of Cirencester from where i live, so 1st sunny sunday found me being dropped off by the wifey.(Two weeks later it's pissing down with rain again)

There is a lot of clay shooting going on which i ignored, but the 30 lane HFT course did take my fancy.

Some one with a HW100 using the HFT course at Old Downs Pursuits.

Though i didn't take advantage of this i did of the sighting and plinking range, with it's many spinning targets, knockdown targets out to 45 yards , and a large board for sighting with a couple of once used Shoot N C targets on it.

Two lanes and four spaces at the sighting and practice range.

Having brought a selection of rifles, a Hills pump and a small bag with some tools and pellets in it i was content to sit at the double bench and seats and plink away, next time i'll take less rifles and some target paper for fine tuning of sighting.

All set up and ready to rock and roll.

I started off using the Air Arms Shamal in .177 with 4.52 AA field diablo pellets, this rifle is heavy, incredibly accurate, but accuracy goes tits up if it's canted.

I get a boner just thinking about my Shamal.

I could not top up on air as i forgot to bring a 14 mm spanner to remove the forster fitting on the pump as the rifle dates from 1989 when diver's bottles where a screw fit, so i had no idea how much air i had in it.

It's a good job the air cylinder is this big on the .177 Air Arms Shamal,it's annoying if you forget the spanner to attach the refill hose.

Fair enough i must of got over 80 shots out of the Shamal so i could of used it, however i had topped it up on air over a year ago so it's nice to know the old girl is still air tight.

The .22 Air Arms s410 for which i did have an adaptor fitting for shot very accurately as well using H&N field target trophy pellets, I did have trouble hitting accurately past 40 yards as i had forgotten how much hold over i needed. I used clip after clip on the s410 and refilled the resevior twice, as i did have the adaptor fitted to the pump for this one.

.22 Air Arms s410 is also a bloody cool bunny basher

Later in the session i did use the ASI Sniper which has proven to be an accurate little springer shooting AA diablo's at around 7 ft/lb, annoyingly this one didn't hit a dickie bird as the sighting was out.

The ASI Sniper is not too bad for an old Gamo.

I met about three pairs using the HFT course who were very affable and friendly, they had rifles such as a BSA Ultra, a HW 100, and one of those Evanix tactical jobs. Also a father and son with a under lever and one of those 715 Dan Wesson rifled barrel co2 pistols which they kindly let me have a go with, i really was impressed with the pistol even if the trigger pull in double action was a little on the heavy side.

I was having so much fun i didn't even notice the clay shooters banging around and was saddened when the wifey informed me by phone she was on her way to pick me up, after all i would look a trifle dodgey walking through Cirencester with three gun baps on my shoulders. Any way that's it for now.

TTFN

Best wishes, Wing Commander Sir Nigel Tetlington-Smythe.   

2 comments:

  1. Can you post or send me by email a picture of the refill assembly for The Shamal please. I have a friend who has one but need to know what parts to get to make a refill assembly ie. thread sizes etc

    ReplyDelete
  2. I have to unscrew the foster fitting i use for the s410 and then the end of the hose will screw directly on to the Shamal, the 14 mm spanner both removes the foster fitting and tightens the hose on my Hill pump to the thread on the Shamal. I suppose back in 1989 with only two mass produced PCP's around there waasn't a need for the myriad of fittings now available, hope that helps.

    ReplyDelete